Wall and floor surfaces must be fully cured, free from laitance, oil, grease, dust and dry. Abrade the surface with wire brush and remove all laitance and loose material. Remove dust from the back of the tiles and pre-wet the wall/floor surface prior to application of tile adhesive.

Mix Tile adhesive powder to water in 1: 0.25 to 1: 0.27 ratio. Powder should be slowly added to water under stirring continuously to obtain a smooth paste. DO NOT ADD WATER TO POWDER. Allow the mixed material to stand for 10 minutes and stir again before application. Spread the adhesive to the surface with a steel trowel in approximately 5mm thickness. Now comb the surface with a serrated trowel. Apply tile to this surface, pushing firmly against the substrate, turning and twisting a little to ensure full contact. On uneven surface thicker application may be required. Clean the tile surface with a damp cloth to remove excess material before adhesive hardens. After mixing tile adhesive will have a working life of 30 minutes. Fill up the joints with DENDRITE TILE GROUT. After application wipe excess material with a damp cloth.