Application wise:
Call us on
91 - 98746 20044
Product Range
- Synthetic Rubber Based Adhesive
- SUPER JOINER
- DENDRITE URGENTA
- DENDRITE DSM 94
- DENDRITE EXP
- DENDRITE FF 555
- DENDRITE FW
- DENDRITE FW M
- DENDRITE PC 65
- DENDRITE PC EXPORT
- DENDRITE PREMIUM 2006
- DENDRITE SP 99 HT
- DENDRITE SP 202
- DENDRITE SR 1010
- DENDRITE SUPREME
- FIXOBOND PC 80A
- DENDRITE PC 99 MS
- DENDRITE PC 69
- DENDRITE SUNKIT
- DENDRITE CLR 88 M
- FIXOBOND PC 70A
- FIXOBOND PC 80A FW
- DENDRITE SPECIAL SPRAYABLE GENERAL
- Polyurethane Based Adhesive
- DENDRITE AT 104
- DENDRITE IM 2010
- DENDRITE OR 1000
- DENDRITE OR 1000 FW
- DENDRITE OR 1005
- DENDRITE OR 3000
- DENDRITE OR 5000
- DENDRITE OR 5000 M
- DENDRITE OR 6500
- DENDRITE OR 7500
- DENDRITE OR 8100
- GENERAL PU 201
- SONA PU 100
- DENDRITE OR 1009
- DENDRITE OR 3000 M
- Formulated-Polyisocyanate as Hardener
- Primer For Footwear
- DENDRITE PHYLON PRIMER
- DENDRITE PUPVC PRIMER
- DENDRITE TPR PRIMER
- OP LEATHER PRIMER
- DENDRITE SC 69
- DENDRITE PRIMER 500
- DENDRITE M 888
- DENDRITE EVA PP PRIMER
- Two Component Epoxy Resin Based Adhesive
- Cyanoacrylate as Instant Adhesive
- Polyurathane Alkyd
- Solvent Cement
- PVA Based Adhesive
DENDRITE WHITE
PVA
Specifications
Method of Application
• Make sure that the surfaces to be bonded are even, clean, dry and free from grease/oil.
• A coat of adhesive is to be applied uniformly on both the surfaces to be joined. Dendrite White can be applied by brush, roller, applicator etc
• Bring both the adhesive coated surfaces in proper contact before adhesive is dried. Pressure is given from one side by using a piece of cloth to avoid bubbles entrapping.
• Press the surfaces firmly together by using nails, clamps, weight, tape etc. Excess adhesive that oozes out from edges may be wiped off with a moisten cloth.
• Bonded surfaces should be kept under pressure for 24 hrs to achieve best result. However, in case of urgency, pressure may be released after 6hrs & assemble can be taken for use.
• In case of highly porous substrates like particleboard, MDF etc. for better bonding apply a thin coat of Dendrite White on the surface and allowed to dry. This will fill the pores of the surface. After drying, buff lightly with sand paper to get smooth uniform surface. Then this surface is bonded as per the method stated above.
Caution
Tighten the container after partially used. If any skin formation observed, then remove the skin before further use. Container should be Stored in a cool & shaded area.
Pack Sizes
50 Kg, 5 Kg, 1 Kg, 500 gm, 250 gm, 200 gm .
-
Wood Bonding
-
Furniture Manufacturing
-
Board Bonding
-
Veneer Bonding
